Category: Weapons

No Ammo, No Primers, No Problem! – Part 1, by M.B.

Introductory Disclaimer: Recharging primers and making black powder, while safe in the author’s experimental experience, can be dangerous. The author and SurvivalBlog.com do not endorse recharging primers, nor making black powder, and you do so at your own risk. Making primers and/or black powder could also be in violation of the laws in your jurisdiction. You are responsible for compliance with all laws in your area. Neither the author, nor SurvivalBlog.com, are responsible for your use of the information in this article. The processes described herein are therefore for informational purposes only. Important Safety Note: Black powder can be dangerous …


Valley Forge Damascus Steel Knife, by Pat Cascio

Today, I’m going to cover something a little bit different in the cutlery world. it is a nice fixed-blade fighting knife, made in Pakistan out of Damascus steel, and marketed by Valley Forge Cutlery. Damascus steel-bladed knives used to be all the rage and it was pretty much restricted to the custom knife-makers’ realm. First, a little bit of history is called for: Damascus steel-bladed knives go back to Damascus, Syria some centuries ago. The development of this steel began perhaps as early as 700 AD, but most point to closer to 900 AD. But “authoritative” sources vary widely. Most …


Choosing a Practical Antique Rifle – Part 4, by Tunnel Rabbit

(Continued from Part 3.  This concludes the article.) Powder Choices for Reloaders A 140-grain bullet weight is popular for the 6.5×55, because it is the best all-around weight for just about anything this cartridge can do, and do at its best.  For flatter trajectories and for lighter game, decisive kill shots are better with 120 to 123 grain bullets.  However, the 140 grain will likely be the most accurate bullet passed 300 yards.  Top velocities and the greatest accuracy is found with most 140-grain bullets and a maximum charge of RL22. However, RL22 is temperature sensitive and results can disappointing …


Choosing a Practical Antique Rifle – Part 3, by Tunnel Rabbit

(Continued from Part 2.) Reloading for a Chilean Mauser Converted to 7.62 NATO In my experience reloading for another Ludwig Loewe Chilean Mauser, I found good accuracy and top velocities that duplicated some of the most accurate 7.62×51 NATO ammunition using IMR3031 for both 150 and 165 grain bullets. Using military brass, somewhere between 38 to 40 grains of IMR3031 under a 165 to 168 grain bullet, will duplicated the old Navy Match Load.  A maximum of 42 grains of IMR3031 will duplicate 7.62×51 NATO trajectories with good accuracy, and that also happens to be close to where these rifles …


Choosing a Practical Antique Rifle – Part 2, by Tunnel Rabbit

(Continued from Part 1.) Antiques versus Modern, Cartridge Pressures, and Barrel Length The long barrel could be awkward to handle when hunting, yet the long barrel produces higher velocities, as much as 300 feet per second (fps) higher in velocity over carbine length barrels.  This is a very important consideration if the rifle might be used for long-range targets. The higher velocity is also beneficial when using standard soft point ammuntion for game at ranges between 100 and 300 yards, and larger big game inside of 200 yards, such as elk. The 29-inch barrel adds approximately 100 fps over the …


Choosing a Practical Antique Rifle – Part 1, by Tunnel Rabbit

For some background, start by reading JWR’s Frequently Asked Questions (FAQ) article, which is considered a standard Internet reference: The Pre-1899 Antique Guns FAQ. Here is an important quote from that FAQ: Q: What constitutes “antique” under U.S. law? A: Although your State and local laws may vary, any firearm with a frame or receiver that actually made before Jan. 1, 1899 is legally “antique” and not considered a “firearm” under Federal law. This refers to the actual date of manufacture of the receiver/frame, not just model year or patent date marked. (For example, only low serial number Winchester Model …


CRKT HZ6, by Pat Cascio

It’s always fun when I get to test a knife design by a real martial artist. Having spent 35 years in the martial arts myself, I’ve run across more than a few wannabe Black Belts who aren’t really a Black Belt at all. It’s easy enough to purchase a piece of paper that states you are an expert in some form of martial arts. For those of you who aren’t familiar with the term “martial art” know that it means a person specializes in a “military art” of some sort. You can always find some martial arts school that teaches …


Boers, Beans, Bullets, and Bear Soup – Part 2, by Tunnel Rabbit

(Continued from Part 1. This concludes the article.) A Rifle for the Recoil Sensitive Around here, .30-06 is more common than .308 Win.  The second most popular in my neighborhood is 6.5 Creedmoor (6.5CM), then 6.5×55, and lastly a wildcat for the AR platform, the 6.5 Timberwolf. Ideally, we would be best off to standardized on .308 Winchester. Yet .30-06 is still king in these woods. It is time tested and found to be the best all around cartridge CONUS, good for mouse to moose, and the occasional Griz, because it can shoot the heaviest .308 caliber bullets with a …


Boers, Beans, Bullets, and Bear Soup – Part 1, by Tunnel Rabbit

This morning, as per usual, I am having more black beans and black bear soup for breakfast on a cold mountain in Montana, waiting for all h*ll to break loose. I prefer beef, but presently bear meat is all that I have. The first few months of a collaspe may be the worst as the desperate and raiding gangs will be active. And then comes several years of famine.  And the rest of the Four Horsemen. Today, I must decide on whether to get a range finder, or a box of 1,000 match-grade bullets for the old war horse: a …


CRKT Attaboy, by Pat Cascio

I don’t usually start out an article by reporting on the designer of a knife. However, this time around, I will. This handy-dandy little folder, known as the “Attaboy” from Columbia River Knife & Tool (CRKT) was designed by Flavio Ikoma, who resides in Brazil. I previously reported on one of his other designs that really impressed me, and I heard back from Flavio about my article. Like many young children, we had dreams of what we were going to do or become when we grew up. I honestly don’t remember much of what I planned to do, other than …


Preparing For The ATF’s Planned Arm Brace Amnesty

I recently had a consulting client ask me about the recent inadvertent “pre-announcement” of an ATF amnesty registration of arm-brace-equipped pistols. The following is a more detailed and updated version of the information that I provided that client: There are somewhere between 3 and 5 million arm-braced pistols in circulation in the United States. Compare that to the just 300,000 to 400,000 bumpfire stocks that were ordered to be turned in or destroyed, during the Trump administration. (Without compensation.) Arm braces were formerly blessed by the ATF as perfectly legal, but they later changed their minds, and they are soon …


Springfield Armory XDm Elite & Black Hills 10mm HoneyBadger, by Pat Cascio

A little over three years back, I reviewed the then-new XDm in 10mm, and found it to be an excellent handgun. However, this review isn’t a rehash of that pistol. This review is an updated version of the XDm Elite, as well as the brand-new Black Hills Ammunition 10mm round that isn’t even yet on the market. My original 10mm handgun was a full-sized Colt Delta Elite, in stainless steel, and I liked it a lot. However, in short order, the gun shot loose. We had also just moved back to Oregon in 1988, and I was in a recent …


CZ-75D Compact, by Pat Cascio

Back in 1976, a new handgun was introduced to the marketplace – all over the world, with the exception of the United States. It wasn’t allowed to be imported directly for some reason – I’m sure it was all about politics. The CZ-75 was really something to brag about, and I really wanted one, for many years. Some folks found that they could secondarily import the CZ-75 from Canada. Unfortunately, they were paying upwards of $1,000 for those guns, and back then that was a huge sum of money. The original 9mm CZ-75 was a full-sized combat/duty gun. The original …


Prepping With Inexpensive .22 Revolvers, by B.F.

I was organizing my gun safes, and realized that I had somehow accumulated five single-action .22 rimfire revolvers. I thought that a short article about them, how accurate or not they are, and whether or not various brands of ammunition make an accuracy difference might be of interest to SurvivalBlog readers. To preview the conclusion, yes, if… I’ll start with the latest acquisition first. I was at a gun show earlier this year, not intending to purchase anything, and ran across one of the latest offerings from Heritage Arms. Heritage has been making the Rough Rider .22 single-action revolver in …


The Ghillie Suit: The Ultimate in Camouflage (Updated)

Note:  This is an update to an article that I wrote for SurvivalBlog, back in September of 2005.  I found that many of the included links had expired, so I have updated them. I’ve also added some important details. — Back in the 18th century, game wardens in Scotland were engaged in an occasionally deadly game of cat and mouse with poachers. These wardens–called “ghillies” in the local parlance of the day were experts in field craft. To catch a poacher was difficult, so the ghillies would cut tree or bush limbs and cover themselves with them as camouflage while …